Transform An Antique Sewing Bench Into Cheap Chic Seats

Decoupage old advertising posters to a discarded stitching bench, and present the whole piece a shimmering pellet finish. This project resulted from an property auction purchase of 40 cents. Using paint I acquired at a yard purchase, and advertising posters I previously had in my stash associated with craft documents, I switched this shabby sow’s ear right into a chic egypt purse. The pearl paint for the finish was the sole supply I needed to purchase to accomplish the project.

These instructions are intended for transforming a classic sewing table, nevertheless the paint and decoupage techniques can simply be modified and put on chairs, trunks and pulaski furniture. Various other poster things, wallpaper, scrapbooking paper, children’s books or even wrapping paper may be substituted for the vintage advertising posters.

Things You will require:

Stitching bench along with removable place
Sandpaper
Rag
Off-white home paint
Paintbrush
only two advertising posters
Measuring recording
Mod Podge
Sponge brush
FolkArt iron pearl white-colored acrylic paint
Upholstery cloth
Scissors
Staple gun

1
Carefully sand everything on the bench except for the upholstered area to roughen the outer lining. This will give your own paint a good foundation to adhere to. Use an old rag to wipe apart the sanding dirt.

Step 2
Coloring the table using left over off-white home paint. My partner and i also painted the interior storage area and the bottom of the removable chair. Used to do maybe not eliminate the existing Naugahyde upholstery on the seat. Permit the paint to dry and add extra coats intended for complete insurance coverage.

Step 3
Rip the edges of one’s posters, or even decorative document, to fit within the boundaries on every single side of the bench. Lay the paper on a flat working surface with the right area facing upwards. Tear the actual paper in the direction of you. This can provide the white, torn edge on the front of the poster. My personal posters measured approximately several inches from the top, bottom and side edges of the bench.

Step 4
Apply the top layer of Mod Podge to 1 side of the bench using a sponge brush. Center the actual poster on the bench part. Press and rub together with your fingers to eliminate bubbles and firmly chair the poster. Continue to monitor the poster since the Mod Podge dries. Press out bubbles and press lower the edges if they reappear. After the Mod Podge dries, apply another layer over the poster and bench area. Repeat on the other side of the bench with the remaining poster. Enable the Mod Podge to dry.

Step {5}
Use a overcoat of FolkArt iron pearl bright paint over the entire decorated surface of the bench, like the posters. The particular pearl fresh paint is translucent and will produce a shimmering haze on the top of bench.

Step {6}
Lay down your furniture fabric in your work surface with the wrong area facing upward. Center the particular seat lid on the fabric with the bottom part facing upward. Measure the inside lip of the seat and the depth of the seat. Cut the fabric using this measurement, and also an in ., entirely round the seat. The additional inch will give you wiggle room while attaching the fabric.

Step 7
Fold one edge of the fabric on the lip of the seat bottom and staple using a staple firearm. Staple all the way throughout the edge. Do not staple in the corners. Flip the fabric on the opposite side. Gently tug the textile, but do not stretch that. Staple the particular fabric alongside this side. Repeat on the remaining edges. Fold the corners diagonally and facing toward the biggest market of the seat. Staple the corners. Nicely trim the surplus fabric across the lip and the corners.